Comments on: SimpleMotion v2 bus termiantor/breakout board eases setup

By: Shanice Shultis

Shanice Shultis — Tue, 10 Dec 2019 12:49:25 +0000

I’ve read the article with terrific satisfaction and also
could know something brand new that I will use for your own additional requirements.

The report is bright and clear, without the additional
useless facts or else. The speech is both brilliant and brilliant, so the further I see, the longer I do enjoy
it! In any case, the information is quite cutting-edge, so like it.

By: Tero

Tero — Mon, 09 Feb 2015 12:26:11 +0000

Din’t know KMotionCNC is open source. I have just downloaded it and will check out the possibilities. Thanks for idea!

First thing to check is the licensing. It depends on that if it can be used.

By: Moronicsmurf

Moronicsmurf — Mon, 26 Jan 2015 22:36:32 +0000

So been digging through the tons of resources surrounding all the drivers and controllers.. And i find an unholy unionen in KmotionCNC (Dynomotion) and Simplemotion V2 being the prob. best.

Due to the fact that simplemotion can run a chain of drivers over SPI, and KmotionCNC have its Gcode parser and trajectory planner freely available as both source and just a dll that can be dropped into any other project.. =)