Comments on: Argon user guide & Granity release this week http://openservodrive.com/argon-user-guide-granity-release-this-week/ Cutting edge without Bleeding edge Thu, 15 May 2025 12:21:32 +0000 hourly 1 http://wordpress.org/?v=4.1.12 By: Tero http://openservodrive.com/argon-user-guide-granity-release-this-week/#comment-329 Sun, 01 Sep 2013 13:48:15 +0000 http://openservodrive.com/?p=805#comment-329 Thanks for the feedback! I totally agree and will use LinuxCNC from now on.

]]> By: PowerQuestion http://openservodrive.com/argon-user-guide-granity-release-this-week/#comment-328 Thu, 29 Aug 2013 06:19:21 +0000 http://openservodrive.com/?p=805#comment-328 Hello,
In your documentation I really think that you should not address to EMC2. EMC2 designation is no longer used for a long time. If you want to add a reference to EMC2, you should instead of: EMC2 a.k.a. Enhanced Machine Controller, nowadays known as LinuxCNC, BE LinuxCNC, previously known as EMC2 a.k.a. Enhanced Machine.

This is your page at: http://granitedevices.com/wiki/EMC2

]]>