Comments on: Acrylic cases for SimuCUBE system

By: Mark

Mark — Sat, 30 May 2020 15:33:45 +0000

Where can we get the DIY kit of SimuCUBE with PSU, IONI and case?

By: TonyT

TonyT — Thu, 24 Mar 2016 16:59:44 +0000

Thanks Tero. I have a ACS CM3 system (ACS motion controller + 3 servo drives in a big box) that has a fan that sounds like a jet airplane — yuck! I need to investigate replacing that fan.

Since I’m not a simulated or real racer, I’m skipping this campaign but congratulations :)

By: Tero

Tero — Sat, 12 Mar 2016 12:31:38 +0000

Noise is my enemy, so we really want to pay attention to that!

By: Tero

Tero — Sat, 12 Mar 2016 12:17:10 +0000

We plan to provide a DIY kit of SimuCUBE with PSU, IONI and case but without motor & wheel etc at the moment. I hope to see full turn-key systems made by our distributors.

By: Tero

Tero — Sat, 12 Mar 2016 12:15:44 +0000

Yes, new IONI firmware gets power consumption limit so it can operate reliably on 320W PSU. In fast wheel turns with high torque drive will clip torque with 320W but we’ll do some tests with that exact combo to see if it is anything to worry about.

By: Ronald

Ronald — Fri, 04 Mar 2016 17:58:33 +0000

Great work! Do you plan to provide a bundle that includes the small Mige, Emergeny Stop button and cables as an OSW kit?

By: Bernhard Berger

Bernhard Berger — Fri, 04 Mar 2016 13:03:47 +0000

320W is probably gonna cut it rather close, but then again without Amps/Voltage specs it doesn’t say much. But nice design and keep up the great work!

By: John

John — Fri, 04 Mar 2016 12:01:08 +0000

Hi Tero,

any news on this? I really can´t wait to get one.

By: TonyT

TonyT — Thu, 03 Mar 2016 16:48:45 +0000

I hope you will use a super quiet fan.

By: Naoya9999

Naoya9999 — Thu, 03 Mar 2016 08:08:21 +0000

Can I use simucube with 320w PSU for 30Nm class servo motor like large MiGE ?